[Esip-envirosensing] Bear deterrence methods for sensor stations

Mon Mar 28 16:59:34 EDT 2016

Hi Brian,
My 2c are to go big or go small. We've had our PV arrays/towers/sensors destroyed in AK (they were not surrounded by electric fence). The only ones that survived were soil temperature sensors that had their own battery and were buried. You could try to do the same with moisture sensors too. You just need to make sure everything is water proof and you need to visit it often and probably install several in case some are dug up or batteries die/get wet.

The other option could be to go big. We also have large heavy waterproof boxes that are bolted to 3" metal conduit structure, constructed in the form of a balance beam with four legs.  (you can see some photos of the 'brainbox' here: http://carbon.wr.usgs.gov/autochamber.html).  We haven't had trouble with bears here, but I imagine we could put long nails through the box outward to inhibit bears from trying to grab it and rip it down.  Additionally, we have had electric fence around this site too. 
Mark

On Mar 28, 2016, at 11:47 AM, Scotty Strachan via Esip-envirosensing <esip-envirosensing at lists.esipfed.org> wrote:

> Brian, I'll chip in on the power side as well.
> 
> Like Renee says, sometimes you have to size the PV array and battery bank for the marginal condition. I have a site in a forest that runs sap flow sensors, a met station, radios, cameras, etc. The clearing is not large, and my solar panels always have some shade on them somewhere, especially in winter. The solution was to run nine 250w panels into two separate charging/battery arrays w/~300Ah+ each and mount the panels at 60deg for snowshed. I only get a couple hours of charging time per day, but it's enough to bring the batteries back up fast.
> 
> Here's the other thing - you don't want non-science systems (like fences, etc) to run down the same batteries that you use for your loggers and data collection. When I have dual-redundant PV/battery systems, I then run a passive power combiner to a main 12v bus and then use fused Low Voltage Disconnects for each subsystem, each set at different cutoff voltages depending on priority. At no time do I allow a system (even dataloggers) to pull down a battery bank lower than 25%, otherwise you just kill your batteries during a long outage and still have no data.
> 
> For instance, your could place your feed to your fence energizer (or it's separate battery trickle charger) with a conservative LVD setting (like 11.5v), and your data collection on 11v or lower. 
> 
> Make sure you have really good grounds on your fence circuit. 
> 
> Example of LVD product I use: http://www.rogue-engr.com/12-Volt-30-Amp-Low-Voltage-Disconnect_p_15.html
> 
> Example of passive combiner I use when I go with parallel PV-charger-battery arrays (this way I can lose a battery, charger, or panel and still have a functioning system, well as run a non-critical device separately from one of the battery banks and still not compromise the science system): http://www.newmarpower.com/Automatic_Power_Selectors/Automatic_Power_Selectors.html
> 
> If you are into electronics, you can get creative with this sort of thing. The trick is to use devices which are not adding liability to the hardware dependency list....
> 
> Cheers,
> Scotty
> 
> 
> Scotty Strachan 
> Coordinator, Environmental Research 
> Department of Geography 
> University of Nevada
> web: scottystrachan.com 
> email: scotty at dayhike.net 
> cell: 775-721-1308 
> 
> On 3/28/2016 10:39 AM, "Renée F. Brown" via Esip-envirosensing wrote:
>> I agree- electric fences are the best way to keep wildlife out. Not sure of your power design, but sounds like you do have some sort of solar panel and battery system. You may need to consider beefing up both your solar panel system as well as your battery bank such that the batteries alone can get you through cloudy and/or snowy days, while the panels are large enough to recharge the battery bank when enough sun is available.
>> 
>> Renee
>> 
>> —
>> Renée F. Brown
>> Sevilleta LTER & Sevilleta Field Station
>> Department of Biology
>> University of New Mexico
>> 
>> 
>>> On Mar 28, 2016, at 11:11 AM, Wyngaard, Jane R (398M-Affiliate) via Esip-envirosensing <esip-envirosensing at lists.esipfed.org> wrote:
>>> 
>>> I worked on some weather stations that had to be protected from baboons - we also had to use electric fences in the end.
>>> 
>>> I wasn’t on the power supply design but is it literally a matter of too little sunshine or would perhaps a more sophisticated recharge system help?
>>> 
>>> Jane
>>> ++++++++++++++++++++++++++++
>>> Jane Wyngaard, Ph.D
>>> Postdoctoral scholar
>>> Instrument software and science data systems Section (398)
>>> 
>>> University of Southern California
>>> NASA Jet Propulsion Laboratory 
>>> 4800 Oak Grove Drive MS: 158-256D
>>> Pasadena, CA 91109
>>> 
>>> Phone:  818/354-6237
>>> Email: Jane.R.Wyngaard at jpl.nasa.gov
>>> http://sunset.usc.edu/~jwyngaar/
>>> 
>>> 
>>> 
>>> From: Esip-envirosensing <esip-envirosensing-bounces at lists.esipfed.org> on behalf of Brian Herndon via Esip-envirosensing <esip-envirosensing at lists.esipfed.org>
>>> Reply-To: Brian Herndon <bherndon at uga.edu>
>>> Date: Monday, 28 March 2016 07:50
>>> To: "esip-envirosensing at lists.esipfed.org" <esip-envirosensing at lists.esipfed.org>
>>> Subject: [Esip-envirosensing] Bear deterrence methods for sensor stations
>>> 
>>> Greetings all,
>>> The Coweeta LTER has environmental sensor stations located throughout the southern Appalachians and as our sensor network has expanded to 68 stations, the incidents of black bear damage have increased.  These stations are located in fairly remote hardwood forests requiring equipment to be hiked in. Many are setup like the image below with soil moisture and temperature probes radiating from the base.  We bury the sensor cables so most of the issues have been with the enclosure and solar panel.  We have tried installing electric fences around the enclosure, but maintaining battery power has been an issue.  I would like to receive any suggestions, hear some war stories, etc. as to how any of you have been able to prevent wildlife damage (especially bears) to sensor stations.
>>>  
>>> Brian Herndon
>>> Information Manager
>>> Coweeta LTER
>>> 706.542.5691
>>> <image003.jpg>
>>> <image003.jpg>_______________________________________________
>>> Esip-envirosensing mailing list
>>> Esip-envirosensing at lists.esipfed.org
>>> http://lists.deltaforce.net/mailman/listinfo/esip-envirosensing
>> 
>> 
>> 
>> _______________________________________________
>> Esip-envirosensing mailing list
>> Esip-envirosensing at lists.esipfed.org
>> http://lists.deltaforce.net/mailman/listinfo/esip-envirosensing
> 
> _______________________________________________
> Esip-envirosensing mailing list
> Esip-envirosensing at lists.esipfed.org
> http://lists.deltaforce.net/mailman/listinfo/esip-envirosensing

<>-<>-<>-<>-<>-<>-<>-<>-<>
Dr. Mark Waldrop PhD
Soil Microbiologist & Biogeochemist
U.S. Geological Survey
345 Middlefield Road, M.S. 962
Menlo Park, CA 94025

office: 650-329-5005
cell/txt: 650-714-9294
lab: 650-329-4503
fax: 650-329-4920
Email: mwaldrop at usgs.gov

carbon.wr.usgs.gov
www.usgs.gov/climate_landuse/clu_rd/
<>-<>-<>-<>-<>-<>-<>-<>-<>

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.deltaforce.net/pipermail/esip-envirosensing/attachments/20160328/164e0389/attachment-0001.html>